Loading Paper
89
6
Loading Paper into Tray 2 and 3
The following procedure describes loading paper into Tray 2 and 3.
Important
❒ Various sizes of paper can be loaded in Tray 2 and 3 by adjusting the positions
of side fence and end fence.
❒ Check the paper edges are aligned at the right side.
❒ Do not stack paper over the limit mark.
A Carefully pull out the paper tray until it stops.
B Square the paper and load it print side down.
C Carefully push the paper tray fully in.
Note
❒ If you load a paper size that is not selected automatically, you will need to
specify the paper size with the control panel. Following paper sizes that
are not selected automatically.
❒ The tray can hold up to 550 sheets.
Reference
p.94 “Changing the Paper Size”
p.96 “Changing to a Size that is Not Automatically Detected”
ANS054S
ANS055S
To Next Page
Loading...
Need help?
General
