Programs
271
7
Using a Program
Follow these steps to recall and use a registered program:
A Make sure that the machine is in facsimile mode and the standby display
is shown.
If the standby display is not shown, press the {Facsimile} key.
B Place the original.
C Press the {Program} key.
D Confirm that [Recall] is selected, and press the registered program number.
The standby display appears.
The programmed fax number appears and the registered settings are recalled.
E Press the {Start} key.
The machine starts to scan the original.
Then, transmission starts with the recalled transmission settings.
Note
❒ Using the program causes the previous settings to be cleared.
❒ If you have no programmed destinations or scan settings as programs, se-
lect the program number, and then enter the fax number of the destination
and select the scan settings you require.
BFT020S
To Next Page
Loading...
Need help?
General
