Copier Functions
93
2
Margin Adjustment
You can make a binding margin.
A Press [Edit / Stamp].
B Make sure that [Margin Adj.] is selected. If [Margin Adj.] is not selected, press
[Margin Adj.].
C Set a binding margin for a front side page. Press [←] and [→] when setting the
left and right margins, and [↓] and [↑] when setting the top and bottom margins.
D Set a binding margin for the back side pages. Press [←] and [→] when set-
ting the left and right margins, and [↓] and [↑] when setting the top and bot-
tom margins, and then press [OK].
Margin on the back side of the page is valid when [1 Sided→2 Sided] or [Com-
bine 2 Sides] is selected.
E Place the originals, and then press the {Start} key.
Note
❒ You can set the binding margin up to 30 mm (1.2 inches) in 1 mm (0.1 inch)
increments.
❒ If you make a mistake, press [←], [→], [↓], [↑], or press [Clear] to set a new
value.
❒ If you do not need to specify the margins for the back side pages in step
C
,
press [OK] and proceed to step
E
.
To Next Page
Loading...
Need help?
General
