Read This First
Safety, Conventions, Trademarks
Safety
Prevention of Physical Injury
1. Before disassembling or assembling parts of the machine and peripherals, make sure
that they are unplugged.
2. The plug should be near the machine and easily accessible.
3. Note that some components of the machine and the paper tray unit are supplied with
electrical voltage even if the main power switch is turned off.
4. If any adjustment or operation check has to be made with exterior covers off or open
while the main switch is turned on, keep hands away from electrified or mechanically
driven components.
5. If the [Start] key is pressed before the machine completes the warm-up period (the
[Start] key starts blinking red and green ), keep hands away from the mechanical and
the electrical components as the machine starts making copies as soon as the
warm-up period is completed.
6. The inside and the metal parts of the fusing unit become extremely hot while the
machine is operating. Be careful to avoid touching those components with your bare
hands.
7. Always connect the power cord directly into a wall outlet. Never use an extension cord.
8. Inspect the power cord for damage. Never cut or attempt to modify the power cord in
any way.
9. Keep the machine away from dust and high humidity. Never expose the machine to
corrosive gases.
10. Never use flammable liquids or aerosols around the machine.
11. Never handle the power cord or plug with wet hands.
Health Safety Conditions
1. Never operate the machine without the ozone filters installed.
2. Always replace the ozone filters with the specified types at the proper intervals.
3. Toner and developer are non-toxic, but if you get either of them in your eyes by
accident, it may cause temporary eye discomfort. Try to remove with eye drops or flush
with water as first aid. If unsuccessful, get medical attention.
4. This machine employs an LED array in the scanner and image writing unit.
To Next Page
Loading...
Need help?
General