NCU Parameters
D418 132 SM
4.9 NCU PARAMETERS
The following tables give the RAM addresses and the parameter calculation units that the
machine uses for ringing signal detection and automatic dialing. The factory settings for
each country are also given. Most of these must be changed by RAM read/write (SP2-102),
but some can be changed using NCU Parameter programming (SP2-103, 104 and 105); if
SP2-103, 104 and 105 can be used, this will be indicated in the Remarks column. The
RAM is programmed in hex code unless (BCD) is included in the Unit column.
The following addresses describe settings for the standard NCU.
Change the fourth digit from "5" to "6" (e.g. 680500 to 680600) for the settings for
the first optional G3 interface unit and from "5" to "7" (e.g. 680700) for the settings
for the second optional G3 interface unit.
Address Function Unit Remarks
Country/Area code for NCU
parameters
Use the Hex value to program the country/area code directly into this address,
or use the decimal value to program it using SP2-103-001
Country/Area Decimal Hex Country/Area Decimal Hex
France 00 00 Hong Kong 20 14
Germany 01 01 South Africa 21 15
UK 02 02 Australia 22 16
Italy 03 03 New Zealand 23 17
Austria 04 04 S'pore 24 18
Belgium 05 05 Malaysia 25 19
Denmark 06 06 China 26 1A
Finland 07 07 Taiwan 27 1B
680500
Ireland 08 08 Korea 28 1C
To Next Page
Loading...
Need help?
General