Copy Image Adjustments: Printing/Scanning
D062/D063/D065/D066 4-136 SM
Registration Buckle Adjustment
When the customer is using special paper, buckle adjustment may be required if paper
feed problems arise.
If the buckle is too large, this can cause wrinkling, creasing, or jams caused by sheets
overtaking the sheets ahead of them in the paper path.
If the buckle is too small, this can cause jams at the registration roller or skew during
paper feed.
1. Enter the SP mode.
2. Open SP1003.
To prevent wrinkling, creasing, or jams, set a smaller value.
To prevent jams at the registration roller or to eliminate skew, set a larger value.
SP1003-001 Registration Buckle Adjustment – Tray, LCT
SP1003-002 Registration Buckle Adjustment – Duplex Tray
SP1003-003 Registration Buckle Adjustment – Bypass Tray
Adjustment range -9 mm ¤ +9 mm (small ¤ large buckle)
Initial value 0 mm (Buckle = 10 mm)
4.14.2 IMAGE ADJUSTMENTS: SCANNING
Before doing the following scanner adjustments, perform or check the printing
registration/side-to-side adjustment and the blank margin adjustment.
Use an S-5-S test chart to perform the following adjustments.
Registration: Platen Mode
To Next Page
Loading...
Need help?
General