Selecting Copy Paper
Select paper you want to copy onto.
There are two ways to select copy paper:
Auto Paper Select
The machine selects a suitable size of copy paper automatically based on the detected original size
and the reproduction ratio you select.
Manual Paper Select
Select the tray containing the paper you want to copy onto: a paper tray, the bypass tray, or the LCT.
See the following table for original sizes and orientations that can be used with Auto Paper Select (when
copying at a ratio of 100%):
Original location Original size and orientation
Exposure glass 11 × 17 , 8
1
/
2
× 14 , 8
1
/
2
× 11 , 5
1
/
2
× 8
1
/
2
ADF 11 × 17 , 8
1
/
2
× 14 , 8
1
/
2
× 11 , 5
1
/
2
× 8
1
/
2
, 10
× 14 , 7
1
/
4
× 10
1
/
2
, A3 , A4
• Only the paper trays set to [Do not Display] or [Recycled Paper] in Paper Type and also set to [Yes]
in Apply Auto Paper Select under Tray Paper Settings can be selected in Auto Paper Select mode.
For details, see “System Settings”, Network and System Settings Reference.
Auto Paper Select
The machine selects a suitable size of copy paper automatically based on the detected original size and
the reproduction ratio you select.
1. Make sure that [Auto Paper Select] is selected.
Trays with a key mark ( ) will not be automatically selected. For details about which trays are
unavailable when [Auto Paper Select] is applied, see “Tray Paper Settings”, Network and System
Settings Reference.
Selecting Copy Paper
129
To Next Page
Loading...
Need help?
General