4. Specify a binding margin for the back side pages. Then press [OK].
If you do not need to specify the margins for the back side pages, press [OK].
• To change the value you entered, press [ ], [ ], [ ] or [ ], or press [Clear], and then specify a new
value.
• Press [ ] and [ ] to set the top or bottom position. Press [ ] and [ ] to set the left or right position.
• You can set the binding margin up to 30 mm (1.2 inches) in 1 mm (0.1 inch) increments.
• Margin on the back side of the page is valid when 1 Sided 2 Sided or Combine 2 Sides is selected.
• You can change the settings for Margin Adjustment under Edit in User Tools. For details about Edit,
see “Edit”.
• If you set a binding margin that is too wide, part of the image may not be copied.
• When making copies in Combine mode, the binding margin is added to the copies after the
combination is finished.
• p.225 "Edit"
Erase Center / Border
This function erases the center and/or all four sides of the original image.
This function has the following three types:
Erase Border
Erases the edge margin of the original image.
Erase Center
Erases the center margin of the original image.
Advanced Copier Functions
161
To Next Page
Loading...
Need help?
General