• Set the original squarely.
• When originals are loaded in the one-pass duplex scanning ADF, the bottom plate rises automatically.
• p.32 "Batch Mode"
• p.33 "SADF Mode"
• p.34 "Mixed Sizes Mode"
• p.35 "Specifying Original Sizes"
Batch Mode
Using Batch mode, you can copy an original that is too large to place in the ADF by placing it in the ADF
in sections (batches). The original will be scanned and stored as a single document.
• Place special originals, such as translucent paper, one by one.
The maximum numbers of sheets you can load in the ADF are as follows:
• Type 1 and 2: 50 sheets
• Type 3 and 4: 100 sheets
1. Press [Special Original].
2. Select [Batch], and then press [OK].
3. Place the first part of the original, and then press the [Start] key.
4. After the first part of the original has been fed, place the next part, then press the [Start]
key.
• When [SADF] is displayed instead of [Batch], specify the Batch mode under Switch to Batch in User
Tools. For details about Switch to Batch, see “Input / Output”.
• To copy subsequent originals in this mode, repeat step 4.
1. Placing Originals
32
To Next Page
Loading...
Need help?
General