4.System Maintenance
129
6. Select the backup destination (USB or Internal hard drive).
For backup on the USB flash drive, select the desired options and click Continue.
To create a bootable image with all the factory default versions of software and settings, select
Fiery factory image. Fiery System Restore automatically creates the factory image as
bootable image. (Non-bootable factory image cannot be created with the Fiery System
Restore feature.)
To create a bootable customized image, select New image with the "Create bootable image"
option checked. This creates a bootable image that contains the current software updates and
settings, including any customizations made to the E-25C configuration.
To create a non-bootable customized image, select New image. This creates a non-bootable
image that contains the current software updates and settings, including any customizations
made to the E-25C configuration.
7. Follow the on-screen prompts to complete the backup.
For a backup using USB 3.0, it will take 10-20 minutes to complete the backup. When the backup
is complete, the E-25C will automatically reboot and enter Idle.
Restoring the E-25C System with Fiery System Restore (WebTools)
If the HDD does not boot, the system must be restored with a bootable backup. If it becomes
necessary to restore the E-25C with a bootable image, the site administrator must contact the
service representative as mentioned in the User manual (Configuration and Setup guide).
To Next Page
Loading...
Need help?
General
