4.System Maintenance
89
Restoring the Factory Default System Image File from the E-
25C HDD Recovery Folder
An image file of the E-25C system is stored in the recovery folder in the E-25C HDD when the system
software is installed to the E-25C. You can retrieve the factory default system by restoring this image
file using the service switch operation. When restored, the main folder, which stores all current data, is
formatted and deleted of the data.
1. Perform the shut down procedure from the copier operation panel [Link to Shutting Down the E-
25C Only].
2. When the E-25C power is down (that is when the diagnostic LEDs are off), turn the main power
switch of the E-25C to OFF.
3. Set the E-25C service switches as shown below. (“1” OFF, “2” ON)
4. Turn the main power switch of the E-25C to ON, then press and release the soft power push button
on the front of the E-25C.
5. Wait until the diagnostic LEDs on the rear panel of the E-25C flash "EE" then "00" and repeats to
indicate ready status.
6. Set the service switches to the following position. ("1"OFF, "2" OFF)
To Next Page
Loading...
Need help?
General
