4.System Maintenance
140
8. Set the service switches as show below ("1": OFF, "2": OFF).
The diagnostic LEDs display "C0" to indicate that the Fiery Server is ready to be restored.
After setting the service switch positions, you have 10 seconds to revert to ready status
(service switch back to "1": ON, "2": OFF) before Fiery Clone Tool begins restoring from the
image file.
9. Wait for the Fiery Clone Tool to format the HDD and restores the image file.
The diagnostic LEDs circulate "C1, C2, C3" to indicate the format and restore procedure is in
progress.
When the restore process is complete, the diagnostic LEDs flashes "CC", then "00" in one
second intervals and repeats to indicate completion status.
If an error occurs during the restore process, the diagnostic LEDs flashes "EE", then the error
code in half-second intervals. [Link to LED Error Codes Related To the Fiery Clone Tools /
Fiery System Restore]
10. Remove the USB flash drive from the USB port.
11. Press and release the power switch on the front panel of E-25C.
E-25C will automatically move to the shutdown procedure.
12. When the E-25C power is down (that is when the diagnostic LEDs are off), turn the main power
switch of the E-25C to OFF.
13. Reboot the E-25C.
14. Optional: After restoring the E-25C, run System Updates to ensure the latest E-25C software
version is installed.
15. Optional: If a backup of the configuration settings is available, restore the configuration settings as
described in this document [Link to Restoring Backup Files]
This can be useful if the configuration backup is more current than the system image backup (for
example, when restored to the factory default) or if the configuration backup includes the job log
and VDP/FreeForm Resources.
LED Error Codes Related To the Fiery Clone Tools / Fiery System Restore
The LED error codes flash "EE", then the error code and repeats when an error occurs.
To Next Page
Need help?
General
