4.System Maintenance
85
WorkStation help.
Job Log:
The site administrator can use Command WorkStation to save a current list of jobs (not the actual jobs)
from the Job Log.
Fonts:
When you reinstall system software or restore the factory default image file, all fonts on the HDDs are
deleted. Resident fonts are reinstalled when you reinstall system software. Any customer-supplied fonts
must be reinstalled by the site administrator (see Command WorkStation Help).
To determine which additional fonts were downloaded to the E-25C, print the Font List before you
reinstall the system software and again after you complete the system software installation. Any fonts
not listed after installation will need to be reinstalled. For more information about managing fonts, see
Command WorkStation Help.
Configuration page:
Before you reinstall a new version of system software, print the Configuration page. The Configuration
page provides a record of the customer’s current Setup configurations.
Backing up and restoring the configuration:
Always back up the current E-25C configuration before you reinstall system software. After the
installation is complete, be sure to restore the configuration that you saved earlier.
Compatibility:
After you upgrade system software, remind the site administrator to upgrade user software on all
computers connected to the E-25C. Using old user software with new system software may negatively
affect the system.
To Next Page
Loading...
Need help?
General
