• Duplex printing is not supported for the following paper types: labels, thin paper, cardstock, thick
paper ([Thick Paper 2], [Thick Paper 3]), the reverse side of thick paper ([Thick 2:Dup.Back], [Thick
3:Dup.Back]).
Bypass Tray
This section explains how to load paper into the bypass tray and change paper size.
Loading standard size paper
• Shuffle paper before loading the stack onto the tray, so multiple sheets are not fed in together.
• Set the size and direction of the loaded paper on the control panel or with the printer driver. Make
sure the settings do not conflict. Otherwise, the paper may jam or the print quality may be affected.
• Load paper with the print side down and in the short-edge feed direction.
• The bypass tray does not support duplex printing.
• When setting long paper to the bypass tray, support it with your hand to ensure it is fed properly.
• Paper feeding process or image quality varies depending on the paper thickness or width.
• Check the print in advance using the same type of paper.
1. Open the bypass tray.
To Next Page
Loading...
Need help?
General
