11. Appendix
Moving and Transporting the Printer
• Disconnect the power plug (by pulling the plug, not the cable) if the power cable or plug becomes
frayed or otherwise damaged.
• Before moving the machine, unplug the power cord from the wall outlet. If the cord is unplugged
abruptly, it could become damaged. Damaged plugs or cords can cause an electrical or fire hazard.
• When moving the machine, hold the handles at both sides, and then lift the printer slowly. Lifting it
carelessly or dropping it may cause an injury.
• When moving the printer after use, do not take out any of the toners, photo conductor units, nor waste
toner bottle to prevent toner spill inside the machine.
• Be sure to disconnect all cables from the printer before transporting it.
• The printer is a piece of precision machinery. Take care to avoid damage during transportation.
• If optional paper feed units are attached, remove them from the printer and move them separately.
Repack the printer using its original packaging for transporting.
• The printer weighs approximately 73 kg (161 lb.).
Moving the Printer
• When lifting the machine, use the inset grips on both sides. Otherwise the printer could break or cause
an injury if dropped.
• Before moving the machine, unplug the power cable from the wall outlet. If the cable is unplugged
abruptly, it could become damaged. Damaged plugs or cables can cause an electrical or fire hazard.
Moving the printer a short distance
• Be sure to place the printer on a smooth and stable place.
201
To Next Page
Loading...
Need help?
General
