bypass tray, make sure paper is not stacked higher
than the paper guides inside it.
Duplex printing Not supported
OHP transparencies
Printer setup
Select [Paper Input] [Paper Type: Bypass Tray]
[OHP transparencies].
Printer driver setup Select [OHP transparencies] in [Paper Type].
Supported paper feeding tray Bypass tray
Paper capacity
Make sure paper is not stacked higher than the
paper guides inside the bypass tray.
Duplex printing Not supported
Additional cautions
• When loading OHP transparencies, take care
not to load them upside down. Doing so may
cause a malfunction.
• It is recommended to place one sheet at a
time.
• Make sure to fan OHP transparencies every
time before printing. Leaving OHP
transparencies loaded in the paper tray may
cause them to stick together and result in a
misfeed.
• If multiple OHP transparencies are fed at the
same time, load them one by one.
• When printing on OHP transparencies,
remove the transparencies one by one as they
are output.
Letterhead
Printer setup
Select [Paper Input] [Paper Type: (tray name)]
[Letterhead].
Printer driver setup Select [Letterhead] in [Paper Type].
Paper Recommendations
83
To Next Page
Loading...
Need help?
General
