• Install the controller board carefully. For details, see "Cautions When Re-installing the Controller
Board".
• p.24 "Cautions When Re-installing the Controller Board"
Installing the Hard Disk
• Do not touch the inside of the controller board compartment. It may cause a machine malfunction or
a burn.
• Before beginning work, ground yourself by touching something metal to discharge any static
electricity. Static electricity can damage the hard disk.
• Do not subject the hard disk to physical shocks.
• When installing the SDRAM module, hard disk, and wireless LAN interface board together, install
them in the following order: SDRAM module, hard disk, wireless LAN board. If the wireless LAN
interface board is already installed, remove it before installing the hard disk.
• Install the hard disk carefully if the SDRAM module is already installed. If the hard disk comes in
contact with the SDRAM module, the SDRAM module may become damaged.
• Before using the new hard disk, you must configure settings in the printer driver.
1. Check the contents of the package.
1. Hard Disk
2. Three Screws
3. Screws for Other Models
4. Key Tops
2. Turn the printer off and unplug the power cord.
Installing the Memory Expansion Units
33
To Next Page
Loading...
Need help?
General
