2. Installing Options
Available Options
By installing options, you can improve printer performance and expand the available features.
• Before installing options, the machine should be turned off and unplugged for at least an hour.
Components inside the machine become very hot, and can cause a burn if touched.
Order of Option Installation
When installing multiple options, the following order is recommended:
1. Attach the 1000-sheet paper feed unit or 2000-sheet paper feed unit
Either the 1000-sheet paper feed unit or 2000-sheet paper feed unit can be attached, but not both.
2. Attach the 1200-sheet paper feed unit
The 1000-sheet paper feed unit or 2000-sheet paper feed unit must have been attached.
To attach this option, contact your sales or service representative.
3. Install the SDRAM module
Install in the slot inside the controller board.
4. Install the hard disk
Install inside the controller board.
5. Install the interface board
Install in the slot of the controller board.
Only one interface board can be installed.
6. Insert SD card options
Insert in the SD card slot of the controller board.
There are two slots for SD cards.
Each slot supports different types of SD cards.
If you want to use two or more SD cards that can be inserted in the same slot, contact your sales or
service representative.
7. Attach the bridge unit
To attach this option, contact your sales or service representative.
8. Attach the 1000-sheet finisher or 2 tray finisher
Either the 1000-sheet finisher or 2 tray finisher can be attached, but not both.
21
To Next Page
Loading...
Need help?
General
