5.System Maintenance
140
Factory Default
Resets all the settings to factory default.
Clears/ resets the contents of the controller memory (all data programmed
by the user, log data application counters) to factory default.
After executing, initial setup menu starts after power-on.
Does not execute anything. Returns to an upper level.
When used to set Paas (Only for CHN)
[Off (Default)/ On]
Sets the tentative density (%) for the economy color print.
[30/ 50 /100]
Sets the conversion mode for the economy color print.
No Conversion: No conversion is executed.
Color Up Mode: Converts into economy color. The image density
is decreased.
B&W Up Mode: Converts into Economy Black and white.
[No Conversion / Color Up Mode / B&W Up Mode]
Sets whether the Air Print function is enabled or disabled.
[Disable (Default) /Enable]
Sets whether to send the debug log via the Ethernet port or USB port or to disable
the Debug Tool function.
[OFF / NIC / USB]
Selects the test pattern.
[0 to 23 / 0 / 1/step]