Inserting/Removing a Memory Storage Device
• Keep SD cards or USB flash memory devices out of reach of children. If a child accidentally
swallows an SD card or USB flash memory device, consult a doctor immediately.
• Do not turn off the main power switch while the machine is saving data to a memory storage
device. Doing so may damage the device. If you turned off the main power switch while data was
being saved, be sure to check whether the data in your device was saved correctly.
• USB flash memory device and SD cards are supported for direct printing. However, certain types
of USB flash memory device and SD cards cannot be used. For details, contact your sales or
service representative.
• This machine supports FAT16 or FAT32 format USB flash memory device and SD cards. Other
forms of memory storage device are not compatible.
• This machine does not support the use of external USB hubs or SD card readers.
• If a memory storage device is being accessed, do not disconnect it and do not turn off the machine.
Doing so can damage the memory device and corrupt its data.
• If the machine is turned off or the memory storage device is removed while data is being accessed,
check that the data stored on it is not corrupted.
• It is possible that any data stored in the memory storage device will be damaged or lost by user
error during operation or software error. Be sure to back up of all data beforehand. The
manufacturer shall not be liable to you for damages or loss of any data produced by using this
function.
• If the media access lamp does not light when a memory storage device is pushed into the media
slot, do the following:
• Reinsert the memory storage device.
• The memory storage device may be broken. Contact the shop where you bought it.
Inserting an SD Card
• This machine supports SD or SDHC memory cards with a maximum capacity of 32GB. SDXC
memory card cannot be used.
• Insert only an SD card into the SD card slot; do not insert any other object. Doing so may cause a
malfunction.
2. Getting Started
32
To Next Page
Loading...
Need help?
General
