112
UKCA and CE RED Compliance Statement:
Hereby, RISCO Group declares that this equipment is in compliance with the
essential requirements of the UKCA Radio Equipment Regulations 2017 and CE
Directive 2014/53/EU.
For the UKCA and CE Declaration of Conformity please refer to our website:
www.riscogroup.com
FCC ID:JE4RP432KPTZ
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation
Changes or modifications to this equipment which are not expressly approved by
the party responsible for compliance (RISCO Group's.) could void the user's
authority to operate the equipment.
FCC Note
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment on and off, the user
is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on to a different circuit from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement:
For the product,under normal use condition is at least 20cm away from the body of
the user,the user must keeping at least 20 cm distance to the product