Risco RisControl User Manual

39
The user can also enter the RisControl while the alarm is activated by using the
“Slide to unlock”. The user can then disarm the alarm or perform usual operations.
Blank Display Mode
Note: This section is applicable only to Security Systems in installations that must
comply with European Norms (EN).
When the Blank Display is enabled in the Security System (i.e., EN Standard
Installation), Quick Arm and Quick Stay are disabled (since the standard does not
allow their use) and the Lock Screen will be displayed, as follows.
Figure 36: Lock Screen – Blank Display Mode
Notes:
• Partition Status is not displayed
• The vertical arc consists of red, orange and green colors (provides no indication
of the RisControl’s partition status)
• The user must enter the PIN Code to unlock the screen

Risco RisControl Specifications

General

Brand	Risco
Model	RisControl
Category	Control Panel
Language	English