26
OPERATING THE RISCONTROL
Entering RisControl
The RisControl operates most of the time in “Screen Saver” mode (see SCREEN
SAVER, page 34). When the user can clicks anywhere on the screen, the RisControl
will exit the Screen Saver mode and switch to the “Lock Screen” (page 35).
To unlock the “Lock Screen”, the user must type a valid PIN Code. Once the lock
screen is unlocked, the “Overview Screen” (page 40) will be displayed allowing the
user to access all the information within the defined permissions for that user, and
to perform all the activities that the user level allows.
Figure 19: Various RisControl Screens
RisControl Session
The “RisControl Session” is the time period that the RisControl remains in the
unlocked mode. It starts after a user enters a valid PIN Code, and it ends
automatically following a predefined “idle” time (Session Timeout) during which
the screen has not been touched. “Session Timeout” is defined in “Settings”
(page 72).
The RisControl will automatically lock following the Session Timeout, during
which the screen has not been touched.
RisControl Main Menu
The RisControl main menu, on the left side of the screen, allows the user to
navigate the various menus, as required.
The main menu is always displayed on the screen and the user can decide to use
the expanded mode, where the text description of each menu appears next to the
menu icon, or, in its collapsed mode, where only the icons of the menus appear.
To Next Page
Loading...
Need help?
General
