Risco RisControl User Manual

12
RisControl Setup
After wiring the RS-485 bus of the Security System successfully, the powerup
procedure will begin automatically and shortly after the installer will be able to
perform the RisControl setup.
The following workflow illustrates the recommended method for setting up the
RisControl.
• Step 1: Selecting the language for the RisControl
• Step 2: Setting the Bus Address (Virtual DIP Switch)
• Step 3: Setting the Wi-Fi connection – for connecting the RisControl to the RISCO
Cloud (optional)
• Step 4: Synchronizing the RisControl with the Security Setup
Step 1: Selecting the language for the RisControl
When the "Welcome" screen is displayed, select the preferred language that will be
used in the RisControl screens.
Figure 2: Welcome Screen
Step 2: Setting the Bus Address (Virtual DIP Switch)
1. Set the virtual toggle switches on the screen below to indicate the BUS address
of the RisControl. For detailed instructions, refer to your receiver’s installation
manual, Setting BUS Accessories ID Numbers section.

Risco RisControl Specifications

General

Brand	Risco
Model	RisControl
Category	Control Panel
Language	English