Installation
Check-out and Power-up
222 MagneMotion
Rockwell Automation Publication MMI-UM007F-EN-P - September 2020
System Power-up
After the QuickStick HT transport system has been installed, all connections must be checked.
Then, an initial power-up must be performed before proceeding any further with the installa-
tion process. This section describes the procedure for the initial installation check-out.
1. Make sure that all installation procedures that are previously described in this chapter
have been completed.
2. Make sure that the system is properly grounded.
3. Connect the QuickStick HT transport system to the electrical services for the facility.
Make sure that the power remains off.
4. Perform a Ground Continuity check from the surfaces of the QuickStick HT transport
system to a known good ground.
5. Apply power to the QuickStick HT transport system.
CRUSH HAZARD: Moving mechanisms (vehicles) have
no obstruction sensors.
Do not operate the QuickStick HT transport system without
barriers in place or personal injury could result in the squeez-
ing or compression of fingers, hands, or other body parts
between moving mechanisms.
AUTOMATIC MOTION HAZARD: Whenever power is
applied, the possibility of automatic movement of the vehi-
cles on the QuickStick HT transport system exists, which
could result in personal injury.
SHOCK HAZARD: Each motor drive can draw
400V DC maximum @ 15 A maximum. Make sure
that the AC circuit suppling power to the power sup-
plies for the motor drives is properly sized and prop-
erly shielded.
NOTICE Use a current-limited power supply to verify the
polarity of all connections before using the system
power supply.
To Next Page
Loading...
Need help?
General
