111
Creating a Patch
Overview Sound 1 Sound 2 Sound 3 Pad Sampler
Menu/System
AppendixSequencer
Control Sens 1–4 (Matrix Control Sens 1–4)
Sets the amount of the Matrix Control’s effect that is applied. If you
wish to modify the selected parameter in a positive (+) direction –
i.e., a higher value, toward the right, or faster etc. – from its current
setting, select a positive (+) value. If you wish to modify the selected
parameter in a negative (-) direction – i.e., a lower value, toward the
left, or slower etc. – from its current setting, select a negative (-)
value. For either positive or negative settings, greater absolute
values will allow greater amounts of change. Set this to “0” if you
don’t want to apply the effect.
Value:
-63– +63
Control Tone 1–4 (Tone Control Switch 1–4)
Matrix Control Tone selects the tone to which the effect is applied
when using the Matrix Control.
Value
OFF:
The effect will not be applied.
ON:
The effect will be applied.
REVS:
The effect will be applied in reverse.
Press the [F5 (PFX)] button to access the PFX (Patch Multi-effect)
editing screen (p. 157).
For details regarding effect settings, refer to the pages shown
below.
•
“Making Effect Settings”
(p. 151)
•
“Making Patch Multi-Effects Settings (PFX)”
(p. 157)
Setting Effects for a Patch (PFX)
Fantom-G_r_e.book 111 ページ ２００９年７月２日 木曜日 午後２時５５分
To Next Page
Need help?
General
