134
Creating a Live/Studio Set
Patch Type
Sets the assignment of a patch (Patch), rhythm set (Rhythm) or
sample set (Sample) to each of the parts.
Value:
PATCH, RHYTHM, SAMPLE
* EXP 1 and EXP 2 parts will depend on the expansion board that is
installed.
Patch Bank
Selects the group to which the desired patch or rhythm set belongs.
Value
USER:
User
PRST:
Preset
USAM:
User Sample
GM:
GM (GM2)
* EXP 1 and EXP 2 parts will depend on the expansion board that is
installed.
Patch Number
Selects the desired patch, rhythm set or sample set by its number.
Value:
001–
* EXP 1 and EXP 2 parts will depend on the expansion board that is
installed.
Mute Switch
Mutes (MUTE) or un-mutes (OFF) each part.
Use this setting when, for example, you want to use the instrument
for karaoke by muting the part playing the melody, or when you
want to play something using a separate sound module.
Value:
OFF, MUTE
The Mute Switch parameter does not turn the part off, but sets
the volume to minimum so that no sound is heard. Therefore,
MIDI messages are still received.
Part Level
Adjust the volume of each part. This setting’s main purpose is to
adjust the volume balance between parts.
Value:
0–127
Part Pan
Adjust the pan of each part. “L64” is far left, “0” is center, and “63R”
is far right.
Value:
L64–0–63R
Receive Switch
For each part, specify whether MIDI messages will be received (ON),
or not (OFF).
If this is “OFF,” the part will not respond. Normally, you should
leave this “ON,” but you can turn it “OFF” when you do not want a
specific part to be playing during song playback.
Value:
OFF, ON
Receive Channel
Specifies the MIDI receive channel for each part
Value:
1–16
Level/Pan
(When the Part Group is Internal/EXP1/EXP2)
Fantom-G_r_e.book 134 ページ ２００９年７月２日 木曜日 午後２時５５分
To Next Page
Loading...
Need help?
General
