189
Using the Pads
Overview Sound 1 Sound 2 Sound 3 Pad Sampler
Menu/System
AppendixSequencer
The Roll function lets you play the sound repeatedly (as if you are
playing a drum roll) as long as you continue holding down the pad.
The Roll function is available only if the pad mode is 1 SAMPLE
PAD or 2 RHYTHM.
1.
Hold down [ROLL] and
press a pad (1–16).
* If you press only [ROLL], the
Roll function will be enabled
for all sixteen pads.
In this state, the sound will
continue repeating as long
as you hold down a pad.
2.
When you release the pad,
it will stop sounding.
* You can’t use this to switch images with the V-Link function (p. 305).
Settings for the Roll function
Press [PAD SETTING]– [F1 (System)] to access the System Setup
screen, and use the Pad Roll Resolution field to specify the speed at
which repeated strikes occur when using the Roll function.
•
“Editing settings common to all pads (System settings)”
(p.
190)
•
“Pad Roll Resolution”
(p. 292)
You can use the pad [ROLL] (BANK) button to switch banks in the
following pad modes.
1.
Press [ROLL] (BANK).
[ROLL] (BANK) will blink,
and pads that correspond to
selectable banks will blink.
The pad corresponding to
the currently selected bank
will be lit.
2.
Press the bank (a blinking
number pad) for the
desired bank.
The selected pad will light.
3.
Press [ROLL] (BANK) once again.
[ROLL] (BANK) will go dark, and the pads will return to their
normal indication.
Using the Roll Function (ROLL)
Switching Banks (BANK)
Pad number
Pad mode Number of banks
9
BOOKMARK 8
13 PART SELECT 4 (INT/EXP1/EXP2/EXT)
14 PART MUTE 3 (INT/EXP1/EXP2)
15 USER GROUP 4
16 FAVORITE 16
Fantom-G_r_e.book 189 ページ ２００９年７月２日 木曜日 午後２時５５分
To Next Page
Loading...
Need help?
General
