25
Overview Sound 1 Sound 2 Sound 3 Pad Sampler
Menu/System
AppendixSequencer
Making Connections
Since the Fantom-G contains no amplifier or speakers, you’ll need to connect it to audio
equipment such as a keyboard amplifier, monitor speaker system or home stereo, or use
headphones to hear its sound.
1.
Before hooking anything up, make sure that the power on all of your gear is turned
OFF.
2.
Connect one end of the supplied power cable to the Fantom-G, and the other end to a
power outlet.
3.
Connect the Fantom-G to your amp/speaker system as shown in the diagram.
fig.02-002.e
Connecting an Amp and Speaker System
To prevent malfunction and/
or damage to speakers or other
devices, always turn down the
volume, and turn off the
power on all devices before
making any connections.
to Power outlet
Stereo headphones
Monitor speakers
(powered)
Power amp
Mixer etc.
In order to fully experience the
Fantom-G’s sound, we
recommend using a stereo
amp/speaker system. If you’re
using a mono system,
however, make your
connections to the Fantom-G’s
OUTPUT A (MIX) jack L
(MONO).
Audio cables are not included
with the Fantom-G. You’ll
need to provide them.
For details on how to install a
Expansion Board (sold
separately), refer to “Installing
the Expansion Board”
(p. 308, p. 310).
The OUTPUT A [MIX] jacks
support balanced output. Use
a correctly wired cable so that
the HOT, COLD, and GND as
printed on the rear panel of the
Fantom-G are correct for the
mixer or other input device
you’re using.
Fantom-G_r_e.book 25 ページ ２００９年７月２日 木曜日 午後２時５５分
To Next Page
Loading...
Need help?
General
