34
Playing
Equalizer settings are saved in system memory.
You can also store the equalizer settings in a setup. Refer to EQ Mode in “System Settings (1. System)” (p. 58). If you’ve chosen
to store the equalizer settings in each setup, the equalizer settings will also be stored when you store the setup (p. 49).
1.
From the Tone screen, press the [Function] button to turn Function on.
The [Function] button will light when the function is on.
2.
Press the [F4 (UTILITY)] button to access the Utility screen.
3.
Use the [F3 (
▲
)] or [F4 (
▼
)] buttons or the [VALUE] dial to select “1. System.”
fig.Util02.eps
4.
Press the [Enter] button or the [F1 (ENTER)] button to access the system setting screen.
5.
Press the [Write] button.
A confirmation message will appear.
If you decide to cancel without saving, press the [F1 (CANCEL)] button.
6.
To save the equalizer settings, press the [F4 (OK)] button.
The equalizer settings, as well as any system parameters you’ve edited will be saved in System memory.
Saving the Equalizer Settings
V-Piano-Grand_e.book 34 ページ ２０１１年２月１０日 木曜日 午後１２時４分
To Next Page
Loading...
Need help?
General
