43
Customizing the V-Piano Grand’s Sounds
5.
Turn the [Value] dial to select the write-destination tone
number.
6.
Press the [F4 (EXECUTE)] button to save the tone.
A confirmation screen will appear.
fig.ToneSave03.eps
If you decide to cancel without saving, press [F1 (CANCEL)].
7.
To save the tone, press [F4 (OK)].
The display will indicate “Executing...” while the data is being
saved. Never turn off the power during this time.
When the data has been saved, press the [Exit] button to return to
the previous screen.
1.
Press and hold down one of the [F1]–[F4] buttons.
A list of the tone parameters will appear.
2.
Continuing to hold down the function button, turn the
[Value] dial to select the desired parameter.
3.
Release the function button.
The parameter you selected is now assigned to that function button.
fig.EditParam03.eps
The state of the button assignments is saved in the tone (p. 42).
The function of opening the utility screen ([Utility]) can be
assigned only to the [F4] button.
The parameters assigned to the function buttons are indicated
using the following abbreviations.
Changing the Parameters Shown in
the Tone Screen
Displayed (abbreviated form)
Parameter Name
SOUNDLIFT
Sound Lift
SOFTPEDAL Soft Pedal Sense
STR.RESO String Resonance
DMP.RESO Damper Resonance
SND.BOARD Soundboard Resonance
KEYOFF Key Off Resonance
TUNING Unison Tune
STRETCH Stretch Tune
HAMMER Hammer Hardness
RESONANCE Cross Resonance
DECAY Decay Time
TONECOLOR Tone Color
DMP.TIME Damping Time
DMP.NOISE Damper Noise Level
V-Piano-Grand_e.book 43 ページ ２０１１年２月１０日 木曜日 午後１２時４分
To Next Page
Loading...
Need help?
General
