119
Standby Control
You can set the screen standby mode to be applied when an input signal is received.
•
Auto
Power-saving mode will activate if no input signals are detected even though a source device is connected to the display.
The message No Signal will appear if no source device is connected.
•
Off
The message No Signal will appear if no input signals are detected.
―
The Standby Control option is only enabled when Source is set to PC or HDMI.
―
If No Signal is displayed although a source device is connected, check the cable connection.
―
If No Signal Message is set to Off, the No Signal message does not appear.
If this is the case, set No Signal Message to On.
•
On
Power-saving mode will activate if no input signals are detected.
Network Standby
This feature keeps the network power on when the product turns off.
•
Off / On
Power Control
Auto Power On
Max. Power Saving
Standby Control
Network Standby
O
On
Auto
O
-
The displayed image may differ depending on the model.
To Next Page
Loading...
Need help?
General
