132
Troubleshooting for Anynet+
Problem Possible Solution
Anynet+ does not work.
•
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices only.
•
Check if the Anynet+ device power cord is properly connected.
•
Check the Anynet+ device’s Video/Audio/HDMI cable connections.
•
Check whether Anynet+ (HDMI-CEC) is set to On in the System menu.
•
Check whether the remote control is Anynet+ compatible.
•
Anynet+ doesn’t work in certain situations. (initial setup)
•
If you have removed and then reconnected the HDMI cable, please make sure to search devices again or turn your product
off and on again.
•
Check if the Anynet+ function of the Anynet device is set on.
I want to start Anynet+.
•
Check if the Anynet+ device is properly connected to the product and check if the Anynet+ (HDMI-CEC) is set to On in the
System menu.
•
Press the TOOLS button to display the Anynet+ menu and select a menu you want.
I want to exit Anynet+.
•
Select View TV in the Anynet+ menu.
•
Press the SOURCE button on the product remote control and select a non- Anynet+ device.
The message “Disconnecting
Anynet+ device ...” appears on
the screen.
•
You cannot use the remote control when you are configuring Anynet+ or switching to a view mode.
•
Use the remote control after the product has completed Anynet+ configuration or has finished switching to Anynet+.
The Anynet+ device does not play.
•
You cannot use the play function when initial setup is in progress.
To Next Page
Loading...
Need help?
General
