[ ENGLISH ]
Basic Recording
+ The ZERO MEMORY function works in both Camera and Player modes.
÷ Youcan mark a point on a tape that you want to returnto following playback.
1. Setthe Power switchto CAMERA or PLAYER.
2. Setthe Modeswitch to TAPE.
3. Press the ZERO MEMORY button on the remote control before the recording or during playback
at the point where you wish to return.
• The time code is changed to a tape counter that is set to ZERO MEMORY with the
[] 0:00:00 (ZERO MEMORY indicator).
• If you want to cancel the ZERO MEMORY function, press the ZERO MEMORY button again.
4. Finding the zero position.
• When you have finished playback, fast forward or rewind the tape in stop mode.
The tape stops automaticallywhen it reaches the zero position.
• When you have finished recording, set the Power switch to PLAYER and press
the 4N(REW) button.
The tape stops automaticallywhen it reaches the zero position.
5. The tape counter with the [](ZERO MEMORY indicator) disappearsfrom the display and the
tape counter is changed to the time code.
/
i J
[ Notes ]
• In the following situations, ZERO MEMORY mode may be canceled automatically:
- At the end of the section marked with the ZERO MEMORY function.
- When the tape is ejected.
- When you remove the Battery pack or power supply.
• The ZERO MEMORY may not function correctly where there is a break between recordings on the tape.
To Next Page
Loading...
Need help?
General