Siemens SINUMERIK 808D ADVANCED Parameter Manual

MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
43230 SPIND_MAX_VELO_LIMS - S1, Z1
rev/min Spindle speed limitation with G96 DOUBLE Immediately
-
- - 100.0 0.0 - 7/7 U
Description: Limits the spindle speed with G96, G961, G97 to the stated maximum value [degrees/
second]. This setting data can be written from the block with LIMS.
Note:
MD 10710 $MN_PROG_SD_RESET_SAVE_TAB can be set so that the value written by the part
program is transferred into the active file system on reset (that is the value is
retained after reset).
Related to ....
SD43210 $SA_SPIND_MIN_VELO_G25 (programmed spindle speed limit G25)
SD43230 $SA_SPIND_MAX_VELO_LIMS (programmed spindle speed limit with G96/961)
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
43235 SPIND_USER_VELO_LIMIT A06 S1, Z1
rev/min Maximum spindle speed DOUBLE Immediately
-
- - 1.0e+8 0.0 - 7/7 U
Description: The user can enter a maximum spindle speed.
The NCK limits an excessive spindle setpoint speed to this value. The SD is effective
immediately.
Corresponds with:
MD35100 $MA_SPIND_VELO_LIMIT (maximum spindle speed)
MD35110 $MA_GEAR_STEP_MAX_VELO (maxmum speed for gear stage change)
43240 M19_SPOS , A12 S1
degrees Spindle position for spindle positioning with M19. DOUBLE Immediately
-
- - 0.0 -10000000.0 10000000.0 7/7 U
Description: Spindle position in [ DEGREES ] for spindle positioning with M19.
The position approach mode is defined in SD43250 $SA_M19_SPOSMODE.
Default positions must lie in the range 0 <= pos < MD30330 $MA_MODULO_RANGE.
Path defaults (SD43250 $SA_M19_SPOSMODE = 2) can be positive or negative and are only
limited by the input format.
43250 M19_SPOSMODE , A12 S1
- Spindle position approach mode for spindle positioning with M19. DWORD Immediately
-
- - 0 0 5 7/7 U
Description: Spindle position approach mode for spindle positioning with M19.
In which signify:
0: DC (default) approach position on the shortest path.
1: AC approach position normally.
2: IC approach incrementally (as path), sign gives the traversing direction
3: DC approach position on the shortest path.
NC setting data
Parameter Manual
344 Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English