The maximum possible number of tools is equal to the number of cutting edges. The MD
must also be set when TOOLMAN is not used.
The buffered data are lost when the machine data is changed.
Related to:
18088 MM_NUM_TOOL_CARRIER N02, N09 W1
- Maximum number of definable tool holders DWORD PowerOn
-
808d-me42 - 0 0 600 ReadOnly
808d-me62 - 0 0 600 ReadOnly
808d-te42 - 0 0 600 ReadOnly
808d-te62 - 0 0 600 ReadOnly
808d-mte40 - 0 0 600 7/2
808d-mte60 - 0 0 600 7/2
Description: Maximum number of definable toolholders for orientable tools in the TO area. The value
is divided by the number of active TO units. The integer result states how many
toolholders can be defined for each TO unit. The data for defining a toolholder are
set with the system variables $TC_CARR1, ... $TC_CARR14.
The data are stored in battery-backed memory.
Application example(s):
-
18102 MM_TYPE_OF_CUTTING_EDGE N02, N09 W1
- Type of D No. programming (SRAM) DWORD PowerOn
-
808d-me42 - 0 0 1 0/0
808d-me62 - 0 0 1 0/0
808d-te42 - 0 0 1 0/0
808d-te62 - 0 0 1 0/0
808d-mte40 - 0 0 1 2/2
808d-mte60 - 0 0 1 2/2
Description: This MD activates the 'flat D number management'.
The default value is zero. This means that the NCK manages the T and D numbers.
Value: Meaning
-----------------------------------------------------------------------------------
0: No 'flat D number management' active
1: 'Flat D number' function is active
18108 MM_NUM_SUMCORR N02, N09 W1
- Resulting offsets in TO area (SRAM) DWORD PowerOn
-
808d-me42 - -1 -1 9000 ReadOnly
808d-me62 - -1 -1 9000 ReadOnly
808d-te42 - -1 -1 9000 ReadOnly
808d-te62 - -1 -1 9000 ReadOnly
808d-mte40 - -1 -1 9000 7/2
808d-mte60 - -1 -1 9000 7/2
Description: Total number of resulting offsets in the NCK.
Machine data
3.2 General machine data
Parameter Manual
90 Parameter Manual, 08/2015, 6FC5397-8EP40-0BA1
To Next Page
Loading...
Need help?
General
