If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy
the problem (page 27). However, note that all
memorized settings will be reset to their initial
settings and you will have to readjust all
settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that
if
service personnel changes some parts during
repair, these parts may be retained.
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 - 20,000 Hz; rated 95 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields
See
page
27
page 56
Amplifier section
Models
of
area
code
U,
CA
1)
Minimum
RMS
Output
Power
(8 ohms, 20 Hz -
20 kHz,
THD
0.09%)
95
W + 95 W
Stereo
Mode
Output
Power
(8
ohms,
I kHz,
THD
1%)
105
W + 105 W
Surround
Mode
Output
Power
2
)
(8 ohms, 1 kHz,
THD
10%)
140
W/ch
I)Measured under the following conditions:
2)Reference poweroutput for front, center, surround
and surround back speakers. Depending on the
sound field settings and the source, there may be
no
sound output.
Area code
U,CA
Frequency response
Analog
Power requirements
120 V AC, 60 Hz
10
Hz
-70
kHz
+0.5/-2
dB (with sound
field
and
equalizer
bypassed)
continued-----------
89
US
To Next Page
Loading...
Need help?
General
Weight and Dimensions
