Suzuki DF140WT User Manual

ENGINE CONTROL SYSTEM 3-39
FUEL INJECTOR OPERATING SOUND (INDIVIDUAL)
1. Disconnect fuel injector wire, and connect the test cord.
\ 09930-89260 : Injector test cord A
2. Connect Gray wire to body ground.
3. Momentarily touch Black/Yellow wire to starter motor mag-
netic switch “B” terminal (connected to battery positive +
terminal), and check for injector operating sound.
Injector operating sound : “Click”

Connecting fuel injector to battery positive for more
than a few seconds may cause injector overheating and
possible injector solenoid failure.
FUEL PUMP 3 SEC. OPERATING SOUND
Turn ignition switch ON and check for fuel pump operating
sound.
Fuel pump operating sound :
Sounds for approx. 3 seconds only
NOTE:
Fuel pump operating sound is low because pump is in fuel va-
por separator. If you cannot hear pump sound clearly, use a
sound scope or long blade screw driver.
COMPONENT INSPECTIONS
NOTE1:
Disconnect remote control wire harness, and connect tester
probe to terminal
A (Gray wire).
FUEL INJECTOR OPERATING SOUND (CRANKING)
1. Touch a sound scope or long blade screw driver to fuel in-
jector body as shown.
2. Crank engine and check for injector operating sound.
Injector operating sound : “Click”
11
1. Vapor separator / High pressure fuel pump1. Vapor separator / High pressure fuel pump
Injector bodyInjector body
“Click”“Click”
“Click”“Click”
11
1. Magnetic switch “B” terminal1. Magnetic switch “B” terminal

Suzuki DF140WT Specifications

General

Brand	Suzuki
Model	DF140WT
Category	Outboard Motor
Language	English