DF90/115 “K2” (’02) MODEL 12-13
High pressure fuel filter
Evaporation hose (Fuel vapor separator to Cylinder head cover)
Fuel hose
(Low pressure fuel pump
to Fuel vapor separator)
Fuel vapor separator
Clamp
Fuel hose / Protector
(3-way joint to Fuel delivery pipe)
Fuel return pipe
Water hose
to Water return pipe
from Fuel return pipe
to Pilot water tube
Water hose
(3-way joint 1 to Fuel return pipe)
Fuel hose / Protector
(Fuel return pipe to Fuel vapor separator)
3-way joint 1
Water hose
from Crankcase upper
High pressure
.
fuel filter
Fuel vapor separator
from Engine holder
to Crankcase lower
Water hose
from 3-way joint 1
Clamp : Fix fuel house and water hose.
Water hose
(Intake manifold
to 3-way joint3)
Water hose
(3-way joint 2 to Intake monifold)
3-way joint 2
3-way joint 3
from Low pressure fuel pump
Water hose
FUEL / WATER HOSE ROUTING
• Do not over-bend (kink) or twist hoses when installing.
• When installing hose clips, position tabs to avoid contact with other parts.
• Check that hoses do not contact rods and levers during either engine operation or standstill.
• Extreme care should be taken not to cut, abrade or cause any other damage on hoses.
• Care should be taken not to cause hoses to be compressed excessively by any clamp when fitted.
Fuel and water hose routing have been changed
from the middle of 2002 year model.
To Next Page
Loading...
Need help?
General
