Suzuki LT-F500F 2002 User Manual

7-46 CHASSIS
REASSEMBLY AND REMOUNTING
Reassemble and remount the steering stem in the reverse order
of removal and disassembly. Pay attention to the following
points:
STEERING SHAFT
• Apply SUZUKI SUPER GREASE “A” to the O-ring and dust
seals before remounting the steering shaft.
+ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
• Install the dust seal
1 to the steering shaft.
• Install the clip
2 to the dust seal.
• Install the new O-ring
3 and dust seal to the steering shaft.
• Tighten the steering shaft nut to the specified torque.
# Steering shaft nut: 49 N·m (4.9 kgf-m, 35.5 lb-ft)
NOTE:
After installing the steering shaft nut, install a new cotter pin into
the steering shaft.
• Apply SUZUKI SUPER GREASE “A” to the steering shaft
holders and dust seals before remounting the steering shaft
holders.
+ 99000-25030: SUZUKI SUPER GREASE “A” (USA)
99000-25010: SUZUKI SUPER GREASE “A” (Others)
$
To prevent the entry of dirt, the dust seal ends
4 must
face forward when installed to the steering shaft.

Suzuki LT-F500F 2002 Specifications

General

Brand	Suzuki
Model	LT-F500F 2002
Category	Offroad Vehicle
Language	English