Suzuki LT-F500F 2002 User Manual

3-42 ENGINE
CLUTCH
CLUTCH DRIVE PLATES
NOTE:
Wipe off engine oil from the clutch drive plates with a clean rag.
• Measure the thickness of drive plates with a vernier calipers.
• If each drive plate is not within the standard range, replace it
with a new one.
% Drive plate thickness
Service Limit: 2.62 mm (0.103 in)
( 09900-20101: Vernier calipers
• Measure the claw width of drive plates with a vernier calipers.
• Replace the drive plates found to have worn down to the limit.
% Drive plate claw width
Service Limit: 12.9 mm (0.51 in)
( 09900-20101: Vernier calipers
CLUTCH DRIVEN PLATES
NOTE:
Wipe off engine oil from the clutch driven plates with a clean rag.
• Measure each driven plate for distortion with a thickness
gauge and surface plate.
• Replace driven plates which exceed the limit.
% Driven plate distortion
Service Limit: 0.10 mm (0.004 in)
( 09900-20803: Thickness gauge
09900-21203: Surface plate
CLUTCH SPRING
• Measure the free length of each coil spring with a vernier cali-
pers, and compare the length with the specified limit.
• Replace all the springs if any spring is not within the limit.
% Clutch spring free length
Service Limit: 33.8 mm (1.33 in)
( 09900-20101: Vernier calipers

Suzuki LT-F500F 2002 Specifications

General

Brand	Suzuki
Model	LT-F500F 2002
Category	Offroad Vehicle
Language	English