10-8 TRANSMISSION AND CRANKSHAFT
CRANKSHAFT INSPCECTION
• Measure the crankshaft runout with V-blocks and dial gauge.
NOTE:
Place the crankshaft onto the V-blocks so that it becomes hori-
zontally.
# Crankshaft runout
Service Limit: 0.08 mm (0.003 in)
" 09900-20607: Dial gauge (1/100, 10 mm)
09900-20701: Magnetic stand
09900-21304: V-block (100 mm)
• Measure the crankshaft web to web width with a vernier cali-
pers.
# Crank web to web width
Standard: 55.9 – 56.1 mm (2.20 – 2.21 in)
" 09900-20101: Vernier calipers (150 mm)
OIL SEAL INSPECTION
• Inspect each oil seal lip for wear and damage.
• If any defects are found, replace the oil seal with a new one.
To Next Page
Loading...
Need help?
General
