19-20 SERVICING INFORMATION
WIRING HARNESS ROUTING
Clamp
Engine stop switch lead wire
20 – 30 mm
(0.8 – 1.2 in)
White paint
To
Magneto
Handlebars
FRONT
Engine stop switch
lead wire
Clamp
Wiring harness
Engine stop switch lead wire
Tighten the ground
terminal on the
CDI bracket.
Do not slack the engine stop switch lead wire.
Fix the center of white tape on the wiring harness with clamp.
Cut the tip of clamp after clamping.
Be careful not to
bind the wiring
harness between
the frame and
radiator louver.
Pass through the
lead wire between
the radiator and hose.
A
Pass through the lead wire
outside of engine mounting bracket.
Fix the center of blue tape
on the wiring harness with clamp.
VIEW A
Magneto
lead wire
Engine mounting bracket
Do not slack the lead wire between the coupler and clamp.
Clamp
IG coil/plug cap lead wire
TPS lead wire
TPS lead wire
TPS lead wire
Engine stop switch
45 ± 10˚
To Next Page
Loading...
Need help?
General
