PERIODIC MAINTENANCE 2-19
HOT STARTER
Adjust the hot starter cable play

A as follows:
• Loosen the lock-nut

1.
• Turn adjuster

2 so the hot starter lever clearance

A mea-
sured at the lever holder obtains approx. 3 mm (0.12 in) when
squeezing the lever until pressure is felt.
• Tighten the lock-nut

1 to the specified torque.
# Hot starter cable play

A: Approx. 3 mm (0.12 in)
$ Cable adjuster lock-nut: 2.2 N·m (0.22 kgf-m, 1.60 lb-ft)
• Check that the hot starter lever moves smoothly from full open
to full close.
• If it does not move smoothly, lubricate the hot start cable.
To Next Page
Loading...
Need help?
General
