52
CONTROLS
Light Switch
When this switch is turned while the starter
switch is at ON, the lights turn on as follows:
O ...... Off
I ....... Meter light, front light, side lights, tail
lights and boom light turn on.
Wiper Switch
IMPORTANT: If no washer fluid is
discharged, do not operate the washer.
Doing so may damage the pump.
IMPORTANT: Operating the wiper with no
moisture on the windshield will scratch
the glass. Apply water or washer fluid
when operating the wiper.
IMPORTANT: In cold seasons, the wiper
blade may freeze to the glass. Operating
the wiper forcibly may damage the wiper
motor.
O ............ Off
I ............. Wiper INT
II ............ Wiper
PUSH ..... Washer
Switches
Slew Speed Switch
Pressing this switch shifts rotation into Slow
speed, bringing its speed down to the
minimum. Slow speed is useful for
performing tasks that require precision
handling even at the cost of speed or
efficiency.
Slow speed
The lamps on the switch and instrument
panel will light up. Used for low speed slew.
The maximum set speed in slow speed can
be adjustable.
Upon shipment, it is set to 7.6 min
–1
(7.6 rpm).
Contact a Takeuchi sales or service outlet
for change.
Normal speed
The lamps will go out and slew will return to
its normal speed.
Supplement: As a safety precaution, the
machine is designed so that you cannot
switch to normal speed while slewing in slow
speed. You must instead bring the rotation
to a temporary halt and then press the slew
speed switch to return to normal speed.
L3B027
L3B028
L3B0291
PUSH
To Next Page
Loading...
Need help?
General
