Tektronix MSO5104B Printable Help

Positive Width
This timing measurement is the distance (time) between the mid reference (default 50%) amplitude points of a positive pulse.
The measurement is made on the first pulse in the waveform or gated region.
Negative Width measurement
This timing measurement is the distance (time) between the mid reference (default 50%) amplitude points of a negative pulse.
The measurement is made on the first pulse in the waveform or gated region.
Negative Duty Cycle
This timing measurement is the ratio of the negative pulse width to the signal period expressed as a percentage. The duty cycle
is measured on the first cycle in the waveform or gated region.
Negative Duty Cycle = (Negative Width) × Period × 100%
Period
This measurement is the time required to complete the first cycle in a waveform or gated region. Period is the reciprocal of
frequency and is measured in seconds.
Frequency
This timing measurement is a measure of the first cycle in a waveform or gated region. Frequency is the reciprocal of the period;
it is measured in Hertz (Hz) where one Hz is one cycle per second.
Delay
This timing measurement is the time between the mid reference (default 50%) amplitude point of two different waveforms
Measurement setup control window (Communications tab)
From the Measure menu, select Measurement Setup; then open the Comm tab.
Overview
Use this control window to set up the instrument for taking automatic communications measurements.
To use
For information on the controls, click the buttons.
■
Measurements
■
Channel
■
Measure | Source
■
Ref Levels
■
Gating
■
Statistics
■
Snapshot
■
Histogram
Measurement setups
278 DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series

Tektronix MSO5104B Specifications

General

Brand	Tektronix
Model	MSO5104B
Category	Test Equipment
Language	English