Tektronix MSO5104B Printable Help

Set up MIPI search parameters
After setting up a MIPI bus, go to the Analyze menu, select Search, and then select the Bus trigger type; then open the Configure
tab.
Overview
Use the controls to set up the MIPI Bus parameters.
To use
For information on the controls, click the buttons.
■
Type
■
Source
■
Copy Settings
■
Search Parameters
■
Search / Mark Controls
Behavior
Clicking an entry in the Type column activates the individual search controls, similar to the one shown above. These controls vary
depending on the search Type. Setting the search conditions is similar to setting the parameters for an Event Trigger.
NOTE. No information will be displayed in this window until you specify at least one search Type in the Search Select Control
Wiondow.
To use
■
Click the Source box and select the bus number or name from the drop-down list.
■
Select the type of bus cycle or activity to search for from the Search For drop-down list.
Analyzing waveforms
332 DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series

Tektronix MSO5104B Specifications

General

Brand	Tektronix
Model	MSO5104B
Category	Test Equipment
Language	English