Behavior. The Trigger Type indicator(s) in the status area change when you apply Trigger Position Correction. In the example
below, the Trigger A indicator changed from A to A' when trigger correction was applied.
NOTE. You can use Trigger Position Correction in any combination for A Event, B Event, or Sequence triggers, including Trigger
After Time and Trigger on nth Event. It is fully compatible with all acquisition and logic qualification sampling modes, Bandwidth
Enhancement, and FastFrame, but not Fast Acquisition.
Trigger setups
DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 477
To Next Page
Loading...
Need help?
General
