Tektronix PS 5010 User Manual

Calibration-PS 501 0
Performance Check Procedure
3. Check Step Size (Resolution)
m. Press the following buttons in the order listed:
a. Connect the POSITIVE connector through a jumper to
the dvrn positive input terminal.
SUPPLY SELECT
NEG
5
b. Connect the front panel common terminal to the dvm
1
common terminal.
1
ENTER
c.
Press the following buttons in the order listed:
SUPPLY SELECT
POS
5
1
1
ENTER
d.
Make sure the OUTPUT is ON.
e. Record the dvrn reading.
n. Record the dvrn reading.
o.
Press the INCREMENT
t button for one step change.
p.
CHECK-that the dvrn reads from 0 mV to -20
mV
from the reading obtained in step n.
q.
Press the following buttons in the order listed:
2
0
ENTER
f. Press the INCREMENT
t button for one step change.
r. Note the dvrn reading.
g. CHECK-that the dvrn reads from 0 mV to +20 mV
from the reading taken in step e.
s. Press the INCREMENT
f button for one step change.
h. Press the following buttons in the order listed:
t. CHECK-that the display reads from -60 mV to
2
- 140 mV more negative than the reading obtained in
0
step r.
ENTER
u.
Leave these connections for the next step.
i. Record the dvrn reading.
j.
Press the INCREMENT t button for one step change.
k. CHECK-that the dvrn reads from f0.060 V to 4e Check Load Effect
+ 0.1 40 V from the reading obtained in step i.
a. Make certain the OUTPUT is OFF.
I. Remove the connector to the POSITIVE front panel ter-
minal and connect it to the NEGATIVE front panel
b. Connect the dvrn directly to the front panel POSITIVE
terminal. and common connectors.

Tektronix PS 5010 Specifications

General

Brand	Tektronix
Model	PS 5010
Category	Power Supply
Language	English