Application Examples Selecting and Configuring Measurement-Chirp
Selecting and Configuring Measurement-Chirp
Follow these steps to select measurements for Chirp measurement:
1. From the application menu, select Measurement > Select > High speed tab.
2. Select the More button to display the following tests:
Receiver Sensitivity
Suspend
Reset from High Speed
Packet Parameter
Chirp
Resume
Reset Suspend
3. Select Chirp measurement.
Configuring the Measurement
Follow the steps to configure the selected measurements:
1. From the application menu, select Measurement > Configure > Configure tab.
2. Configure the following options:
Option Set to
Select DUT
Host, Device
Host EL_33, EL_34
EL_35
Device EL_28, EL_29, EL_31
Source Ch1-Ch4, Ref1-Ref4
xxx
3. Select to acquire the data.
Viewing Results-Chirp
To view the results of the tests, follow these steps:
1. Run the application and from the application menu, and select Results > Summary. The next figures
show the result of a Chirp Device measurement.
120 TDSUSB2 Universal Serial Bus Measurements Package
To Next Page
Loading...
Need help?
General
